TOPIC: Installing Carburetor welch plugs properly?

Installing Carburetor welch plugs properly? 13 years 3 weeks ago #48940

La007 Topic Author Offline Junior Boarder Posts: 74 Thank you received: 0	Should the be installed with the cupped side facing in or facing out, and be installed with a socket of slightly smaller diameter? Is there anything else that should be done? Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.

professor Offline Gold Boarder Posts: 758 Karma: 87 Thank you received: 1	You put them in with the " bulge " so to speak facing out. Then take a flat ended object about 1/2 the OD and give it a good bump to flatten it out.----That operation expands the diameter to hold the plug in place. Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.

Ponyboy Offline Gold Boarder Posts: 605 Karma: 24 Thank you received: 0	do not use any sealer for this, when the plug expans it will cut the excess off and that will get stuck possibly in an orfis that you just cleaned, and if fuel resistant.....well you see where this is going. Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.