Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Merc 800 distrbutor cap?

Merc 800 distrbutor cap? 10 years 2 months ago #99759

  • Terrydi
  • Terrydi's Avatar Topic Author
  • Offline
  • Gold Boarder
  • Gold Boarder
  • Posts: 782
  • Karma: 60
  • Thank you received: 74
Hello all,

Tuning up my 61 Merc 800 after experiencing some hesitation coming out of the hole.

Had this problem before and determined one of the cylinder bleed check valves was leaking. Checked them again and sure enough #3-4 was leaking a bit. I had an extra new valve so went ahead and replaced it.

Decided to replace fuel pumps and also checked and cleaned carb filters and needle valves and bowls.

Have a breaker plate with refurbished points with new rotor ready to go. But looking at the distributor cap I question the condition of the poles and would be interested to hear others opinions. All 6 appear the same a 1 shown here and there are no cracks in the plastic. I seem to recall spending over a hundred bucks last time I replaced it.

Thanks,
Terry
Attachments:

Please Log in or Create an account to join the conversation.

Re:Merc 800 distrbutor cap? 10 years 2 months ago #99778

Clean them and go, but where is the center carbon brush?

Please Log in or Create an account to join the conversation.

Re:Merc 800 distrbutor cap? 10 years 2 months ago #99780

soap and hot water and a brush will do well a knife works on the metal. rinse with Hot water and blow dry. just a tad of grease on the side of the carbon.

Please Log in or Create an account to join the conversation.

Re:Merc 800 distrbutor cap? 10 years 2 months ago #99975

  • Terrydi
  • Terrydi's Avatar Topic Author
  • Offline
  • Gold Boarder
  • Gold Boarder
  • Posts: 782
  • Karma: 60
  • Thank you received: 74
Thanks Guys,

Removed the carbon buildup by scrapping gently with a knife blade and then polished up with a fine abrasive pad.Washed out with soap and water an finished by spraying with electrical contact cleaner.

And was sure to reinstall the brush before reassembling.

Terry

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Time to create page: 0.231 seconds

Donate

Please consider supporting our efforts.

Glassified Ads

1967 23 ft powercat flybridge
( / Boats)

noimage
11-17-2024

Mercury outboard
( / Engines)

noimage
11-03-2024

Classic Mercury Outboard Motors
( / Engines)

Classic Mercury Outboard Motors
10-18-2024

FG Login

FiberGoogle

Who's Online

We have 10562 guests and no members online