TOPIC: need a little help please

need a little help please 10 years 3 months ago #100499

jnjw
Offline
Fresh Boarder
Posts: 6
Thank you received: 0

we got are 1966 homelite/bearcat to run,so we ran it for about 3 minutes and when we checked the oil level it was empty.
we had filled it up with 2 quarts of engine oil the day before.
all the new oil is in the trash can that we filled with water to run the motor in.
any ideas on where the leak would be?

Please Log in or Create an account to join the conversation.

Re:need a little help please 10 years 2 months ago #101147

rickrodt
Offline
Fresh Boarder
Posts: 7
Karma: 1
Thank you received: 0

It is my guess that you have a leaking bottom crank seal. There is a coupler connected to the lower unit drive shaft and crankshaft spline. If the sealing surface is grooved, then the oil will run past the oil seal and leak out or if the seal is bad, then it will leak there. It is just my guess. I am sure others will come up with some other suggestions.

Please Log in or Create an account to join the conversation.

Re:need a little help please 10 years 2 months ago #101150

satx78247 Offline Contributing Member Posts: 2688 Karma: 66 Thank you received: 3	jnjw; rickrodt, WELCOME ABOARD. yours, satx Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation. Resistance to tyrants is obedience to Almighty God. Thomas Jefferson, 1803

Re:need a little help please 10 years 2 months ago #101179

rickrodt Offline Fresh Boarder Posts: 7 Karma: 1 Thank you received: 0	You are welcome. Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.