Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: 1959 Mark 55A Disassembly

1959 Mark 55A Disassembly 7 years 1 month ago #134388

Regards. I am new to Mercury's but reasonably handy with Johnyrudes...
Starting a minor disassemble a Mark 55 for cleaning. Is it easier to disconnect the choke solenoid power source and leave it attached to the top engine cover? these Mercs seem "tight" to work on...

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134389

they have either a eye bolted or a knife connect under a rubber most likely. leave the solenoid and don't forget the ground wire.

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134392

Thanks. I assumed there might be a way to disconnect under the rubber sleeve. The ground is attached at the solenoid mount but broken free on the other end...

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134395

the broken end attaches to the bolt that hold the mag adjustment plate on. must be grounded to work the choke.

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134410

I managed to disassemble and repair the recoil and clean everything up. The lower unit drain plug is missing so it has been without gear oil for a while. I pulled the lower unit and inspected the impeller - will change it before I run it. While cleaning it the shift cams came off and hadn't marked their orientation. So... my next question is - do the shift cams need to be aligned a specific way on the shaft? The engine was in neutral.

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134411

Figured it out... Put the top cam in the housing with a bit of grease and the engine tipped up horizontal. Then slid on the lower unit. I was careful to line up the water tube and it slid together nicely. Shifts into forward neutral and reverse now.

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134414

Yes but does the reverse locks work right. that is what the shift cams do.

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134416

Humph. Not sure. Prop spins freely both ways in neutral, neither way in forward, and will click as turning clockwise in reverse...

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134420

when you tilt the motor down do the hooks go over the tilt pin? and when you put it in neutral do they stay engaged?

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134429

They seem engaged in forward and not in reverse. So that would not be right...

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134430

correct. the shaft is right but the lower cam is on the shaft wrong.

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134431

Okay. Can you explain how the lower cam can be correctly aligned?

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134445

1 914 310 7086 call me.

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134448

Roger. I am in the mountain time zone so it is a bit late out east. I am off work friday so will call in the morning.
Thanks

Please Log in or Create an account to join the conversation.

1959 Mark 55A Disassembly 7 years 1 month ago #134450

10-4

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Time to create page: 0.190 seconds

Donate

Please consider supporting our efforts.

Glassified Ads

1967 23 ft powercat flybridge
( / Boats)

noimage
11-17-2024

Mercury outboard
( / Engines)

noimage
11-03-2024

Classic Mercury Outboard Motors
( / Engines)

Classic Mercury Outboard Motors
10-18-2024

FG Login

FiberGoogle

Who's Online

We have 5319 guests and no members online